c.Do not use the tool if the switch does not turn the tool on or off. Any tool that cannot be controlled with the switch is dangerous and must be repaired.
d.Disconnect the tool from the air source before making any adjustments, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool unintentionally. Turn off and detach the air supply, safely discharge any residual air pressure, and release the throttle and/or turn the switch to its off position before leaving the work area.
e.Store the tool when it is idle out of reach of children and other untrained persons. A tool is dangerous in the hands of untrained users.
f.Maintain the tool with care. Keep a cutting tool sharp and clean. A properly maintained tool, with sharp cutting edges reduces the risk of binding and is easier to control.
g.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that affects the tool’s operation.
If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
h.Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended for use with the specific tool model, increases the risk of injury to persons.
Service
a.Tool service must be performed only by qualified repair personnel.
b.When servicing a tool, use only identical replacement parts. Use only authorized parts.
c.Use only the lubricants supplied with the tool or specified by the manufacturer.
Air source
a.Never connect to an air source that is capable of exceeding 90 psi. Over pressurizing the tool may
cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated
b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool.
Such gases are capable of explosion and serious injury to persons.
Save these instructions.
SKU 98896 | For technical questions, please call | Page 5 |
