Harman-Kardon HKTS30SAT-2 manual Important Make sure the + and bare wires do not touch

NOTE: If you’re running the speaker wire through the wall, you can bring it out directly behind the wall-mount bracket’s location and insert it through the bottom opening in the wall portion of the wall-mount bracket, as shown in the illustration. Inserting it will keep the wire completely hidden from view once the installation is complete.

Insert wire into bottom opening

Bring wire out through here

5.If you’re not running the speaker wire through the wall, insert it through the wall portion of the wall-mount bracket, as shown in the illustration.

6.Pass the speaker wire through the speaker portion of the wall-mount bracket, as shown in the illustration.

Bring wire in through here

Bring wire out through here

7.If you have not already removed the speaker’s base, do so by pulling it straight off the speaker, as shown in the illustration. Applying even pressure to both sides of the base will allow it to slide off smoothly.

Apply pressure evenly	Lift base straight
to both sides of base	off speaker

CAUTION: Before making speaker connections, be sure that your receiver or amplifier is turned OFF and, preferably, its AC cord is unplugged from the AC outlet.

8.Connect the speaker wire to the speaker terminals, as shown in the illustration:

•Press down on the top of the terminal to open the connection hole.

•Insert the wire’s bare end all the way into the hole.

•Release the terminal to secure the wire.

Insert the conductor with the colored band into the speaker’s

red ( + ) terminal, and insert the other conductor into the speaker’s black ( – ) terminal.

+ –

Push down on cap	Insert bare wire	Release cap
to open hole	into open hole	to secure wire

IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch

each other or the other terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier.

9.Slide the speaker portion of the wall-mount bracket onto the speaker, as shown in the illustration. Fit the wall-mount bracket’s grooves onto the rails in the speaker, and apply even pressure on both sides of the wall- mount bracket so it slides straight onto the speaker.

•Push the wall-mount bracket all the way onto the speaker until it snaps into place.

•Pull any slack speaker wire back through the wall-mount bracket as you slide the wall-mount bracket onto the speaker.

Push down evenly on both sides of wall-mount bracket

Fit bracket grooves onto speaker rails

10.Slide the speaker onto the wall-mount bracket’s wall section, as shown in the illustration. Pull any slack speaker wire back through the wall-mount bracket's wall section.

Slide speaker onto wall-mount bracket

11.Fit the metal stop plate into the recess on the bottom of the wall-mount bracket with the pad facing the bracket, and fasten it to the bracket using two of the supplied

screws. Fastening it will prevent the speaker from detaching from the wall-mount bracket and will hold the speaker in position as you rotate it on the wall-mount bracket.

Stop plate

Supplied screws

4