“k” Measured When New:
Top: _________________________
Bottom: ______________________
| Nominal "k" | "u" Dimension | "t" Dimension | ||
Capacity Code | Dimension* | inch (mm) | inch (mm) | ||
| inch (mm) | Standard | Discard | Standard | Discard |
|
| ||||
|
|
|
|
|
|
080S | 4.76(121) | 2.86(72.6) | 2.72(69) | 1.89(48) | 1.8(45.6) |
100L, 100S | 5.16(131) | 3.43(87) | 3.26(82.7) | 2.36(60) | 2.24(57) |
|
|
|
|
|
|
150S | 5..6(142) | 3.91(99.4) | 3.72(94.5) | 2.76(70) | 2.62(66.5) |
200S | 7.13(181) | 4.4(112) | 4.19(106.4) | 2.8(71) | 2.66(67.5) |
|
|
|
|
|
|
*These values are nominal since the dimension is not controlled to a tolerance. The "k" dimension should be measured when the hook is new - this becomes a reference measurement. Subsequent measurements are compared to this reference to make determinations about hook deformation/stretch. See Section 5.7 of ER2OM, “Hooks - Stretch”.
Table
| “P” Dimension | “d” Dimension | |||
Capacity Code | inch (mm) | inch (mm) | |||
| Standard | Discard | Standard | Discard | |
|
|
|
|
| |
080S, 100L, 100S, | 6.18 (157.0) | 6.37 (161.7) | 0.44 (11.2) | 0.42 (10.6) | |
150S, 200S | |||||
|
|
|
| ||
|
|
|
|
| |
16