Hardware Reference - Flextight 848 | 13 | |
Setting up the Scanner | ||
|
Installation Procedure, FireWire Interface
1.Place the scanner on a table near your computer with the front facing away from you. Make sure that the location you choose meets all environmental - and electrical requirements as described on page 11.
2.When using a FireWire interface connection, it is not necessary to switch of your computer and other connected units. Connect a FireWire cable from one of the FireWire connectors on your scanner (see Back Panel & Connectors on page 10) to either the computer's FireWire connector or to a free FireWire connector on any other FireWire device already connected to your computer.
3.Connect the round connector from your power supply to the round power supply socket on the back of the scanner.
4.IMPORTANT: Make sure that the wall socket you are planning to use meets the electrical requirements outlined earlier.
Plug the Flextight 848 power supply into a wall socket. Note that the power supply may emit a low buzzing sound when plugged in. This is normal and will not damage the power supply or scanner.
5.Turn the scanner around so that the front is facing you.
6.Your system is assembled. Turn on your computer and install the FlexColor image scanning software.
