Hardware Reference - Flextight 848 | 9 | |
Front Panel | ||
|
Front Panel
A | D |
| |
| E |
| F |
B | G |
C | H |
Figure 1: Front panel features of Flextight 848 |
|
AFeed Table: must be in lower position for normal scanning. When scanner is not in use you can turn it to upright position flushing with the scanner front to protect it from dust etc. Adjust to horizontal position when using the 35 mm slide mount holder (see page 15).
BLight Table: for viewing originals. The grid helps you to align your transparent originals.
CTransparency Holder Guide: all transparency holders fit between two rails to keep them straight.
DOriginal Holder Clasp: all original holders slide into a slot here and are held in place by a magnetic clasp.
EPower Switch: press here to turn the unit on/off.
FPower Indicator (Green): Remains lit when ready to scan. Flashes when first installed to indicate that firmware must be loaded (it will be loaded automatically when you run FlexColor).
GMotor Drive Indicator (Yellow): lights when the scanner is repositioning the optics to scan in a new format or when drum is repositioning.
HScan Indicator (Red): lights when scanning. Do not touch the scanner while this indicator is lit. If the light is flashing when not scanning, then an error has occurred - please contact your Flextight dealer for assistance.