Hardware Reference - Flextight 848 | 15 | |
Operating Instructions | ||
|
Operating Instructions
(See Figure 4 opposite).
1.It is assumed that the scanner and FlexColor software have been properly installed.
2.If not already done, turn the feed table (A) to normal position.
3.Press the red power button (F) on the front of the scanner to switch it on. The green light (G) starts flashing. This means that no firmware has been downloaded yet. It will be downloaded automatically later when you first run the FlexColor program.
4.Turn on your computer and start the FlexColor program. The green light (G) will stop flashing indicating that firmware has been downloaded to the scanner.
5.Select the original holder (K) that matches your original:
•For transparencies, choose one of the holders that has a square hole in it. The original must completely fill the hole with no edges showing. Also, no edges of the original must extend past the outer edges of the holder.
The feed table (A) must be in normal position.
•For reflectives, select the large
The feed table (A) must be in normal position.
•For 35 mm slide frames use the optional 35 mm slide mount holder.
The feed table (A) must be adjusted to horizontal position. This is obtained by lifting the table slightly upwards while pushing it gently into the scanner.
Please note that when scanning 35 mm slide frames in the 35 mm slide mount holder it is recommended to use autofocus. See the FlexColor Software Reference for details.
continues...
