Hatteras Hammocks none instruction sheet Double Cushioned Swing

If you have any questions regarding our products, call our toll-free consumer customer service line: 800.643.3522 Visit our web page: www.hatham.com

Double Cushioned Swing

Congratulations on your purchase of the Hatteras Hammocks® Double Cushioned Swing.

We believe that you will find it a product of unsurpassed quality and durability.

Hatteras Hammocks designed the Double Cushioned Swing to be both beautiful and functional using only the highest quality materi- als. It may be hung from a sturdy limb or beam (strong enough to support at least 450 lbs.) or from one of the swing stands that we offer. We hope you will enjoy years of pleasure and relaxation from this swing.

The box contains:		Hardware:
1	- Double Swing Cushion
1 - Oak Top Stick (4 sided)		2 - 3" x 3/8” Carriage Bolts
1	- Oak Bottom Stick (5 sided)	2	- 2 1/2" x 3/8” Carriage Bolts
2	- Curved Oak Arms	2	- 1 1/4" x 3/8” Carriage Bolts
2	- Chain and Ring Assemblies	10	- 3/8” Nuts
2	- Tree Hooks	14	- 3/8” Washers

You also will need:

A 9/16" wrench

An electric drill (not necessary if you plan to hang your swing on a swing stand).

Assembly Instructions:	Fig. 2
NOTE: If you plan to hang your Double Cushioned Swing on
a swing stand, make sure your stand is assembled according
to its instructions before you begin assembling your swing.

1.Insert the top stick (4 sided) through the sleeve at the top of the swing cushion back (the sleeve attached to the smallest section of cushion). Next, slide the bottom (5-sided) stick into the sleeve at the

bottom front of the cushion (the sleeve attached to the

	largest	through the second hole from the end of the top
	section of cushion). Make
		stick. (See Fig. 2) HAND TIGHTEN ONLY using a washer
	sure the narrowest flat side of the
Fig. 1		and a nut.
	bottom stick is facing up into the curve
	of the arm. If this is inserted in the wrong	3. To connect the other end
	direction, completely remove the stick				Fig. 3
		of the same arm to the
	and insert correctly. Incorrect insertion will
		bottom stick, insert a 3"
	cause chafing and possibly tearing of the
		carriage bolt, first
	fabric.
		through		the
	NOTE - If you plan to attach a canopy to	bottom hole of the
		curved arm. (See
	your swing at the time of swing assembly,
		Fig.	3)	then
	please refer to your Double Cushioned
		through		the
Swing Canopy Instructions now. Follow the instructions for
		second hole from
the assembly of the canopy through step #6. Then, return
		the	end of	the
to this instruction sheet, skipping steps #2-#4, and picking

up the swing assembly instructions at step #5.

bottom stick.

4. Repeat steps 2

2.To connect the swing arms, position each arm with two and 3 for holes at the top. (See Fig. 1) Insert (from the front to back) the other arm. a 2 1/2" carriage bolt through the arm’s top hole then

5005 p.1 1.OD