INSTALLATION INSTRUCTIONS WGI-F1, F2, F3, F4
INTERIOR WINDOW GUARDS
FOR 1994 – 2008 FORD WINDOW VANS
TOOLS REQUIRED: |
|
| |
Power Drill | Ratcheting Wrench | ||
1/8” Drill Bit | |||
Phillips Screw Driver | Plastic Cutting Tool (utility knife or tin snips) | ||
Metric Socket set |
|
| |
HARDWARE: |
|
| |
QTY | DESCRIPTION |
| PART# |
115 | #10 x ½” Sheet metal screws |
| GSM34185 |
30 | #10 X 1 ¼” Sheet metal screws |
| GSM33197 |
24 | #10 Flat Washer |
| GSM31003 |
15 | M4 x 7mm Hex nuts |
| GSM30200 |
24 | ½” Nylon spacers |
| GSM20095 |
2 | Window Latch cover plate |
| |
2 | SM10260 | ||
SUBASSEMBLY:
1.Remove seats and seat belts for better access to the windows.
2.Remove plastic trim surrounding the fixed body windows. Save the plastic trim for reinstallation.
3.Determine which guard goes to each window. NOTE: The perforated diamond shaped holes has one side that is smoother than the other. The smoother side goes towards the inside, facing the passenger.
DOOR WINDOW GUARDS:
1.In order for guard to fit properly on frame, you must permanently remove the upper plastic trim on doors. The top of the lower door panel may have to be trimmed approximately ¼” to ½”. (Note: Place guard on window frame to determine possible trimming). See section 8 – door window guard does not have cutouts for window latches (making them inoperable).
2.With the doors open, hold the window screen up to the window/door frame. The guard framework should fit evenly around the window frame.
3.Mark a few holes at the top of the door frame using the predrilled holes on the screen framework as a guide. Do not mark holes for the sides or bottom yet.
4.Put on Safety goggles.
5.Remove window guards and drill holes as marked with a 1/8” drill bit.
6.Attach window screens by using #10 x ½” sheet metal screws. Now locate and mark the balance of holes, drill and attach, starting at the top and work your way down.
7.If vehicle has plastic upper door trim, do not reinstall.
