Havis-Shields F2, WGI-F1, F4, F3 Window Latch cover plate Trim cut headliner if desired

3.Notching Plastic:

•The window trim for the first drivers’ side window (F1-1) must be cut where the pop out window latches are located.

•Mark the “V” shaped foot print of latch and cut plastic trim. The latches will bolt back against metal at the original location.

4.Final Touches:

•The trim sections at the top and at the rear doors may stick out a little at the top where it meets the headliner.

•Use a #10 x 1 ¼” Sheet metal screw to secure it down at the top of the trim.

•Some trim panels between windows may also need sheet metal screws to secure them.

•Attach supplied Window Latch cover plates as shown below using #10 x ½” sheet metal screws as shown below.

NOTE: The headliner will push against the window guards. This may cause the headliner to buckle slightly. If desired, the headliner can be carefully trimmed (cut) with a razor knife where it meets the window guard. This will alleviate the buckling headliner.

Window Latch cover plate

Trim (cut) headliner if desired

WGI-F1-F2-F3-F4_INST_7-08