Hayter Mowers 111-2842 Rev B Operating Tips, Removing the Side Discharge Chute, Cutting Grass

Removing the Side Discharge Chute

To remove the side discharge chute, reverse the steps above.

Important: Lock the side discharge door after you close it (Figure 38).

Figure 38

Operating Tips

Cutting Grass

•Cut only about a third of the grass cutterblade at a time.

•When cutting grass over 150 mm tall, mow at the highest cutting height setting and walk slower; then mow again at a lower setting for the best lawn appearance. If the grass is too long, the mower may block and cause the engine to stall.

•Mow only dry grass or leaves. Wet grass and leaves tend to clump on the lawn and can cause the mower to plug or the engine to stall.

Wet grass or leaves can cause serious injury if you slip and contact the cutterblade. Mow only in dry conditions.

•Alternate the mowing direction. This helps disperse the clippings over the lawn for even fertilization.

•If the finished lawn appearance is unsatisfactory, try one or more of the following:

–Replace the cutterblade or have it sharpened.

–Walk at a slower pace while mowing.

–Raise the cutting height on your mower.

–Cut the grass more frequently.

–Overlap cutting swaths instead of cutting a full swath with each pass.

–Set the cutting height on the front wheels one notch lower than the rear wheels. For example,

set the front wheels at 51 mm and the rear wheels at 64 mm.

Cutting Leaves

•After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to make more than one pass over the leaves.

•If there are more than 130 mm of leaves on the lawn, set the front cutting height one or two notches higher than the rear cutting height.

•Slow down your mowing speed if the mower does not cut the leaves finely enough.

16