Manuals / Hayter Mowers / Lawn and Garden / Trimmer

Hayter Mowers 407F LUBRICATION Lubricate the Jackshaft Assembly, Change Engine Oil, Maintenance

Models: 407F

1 30

Download 30 pages 43.15 Kb

Page 15

Image 15

MAINTENANCE

LUBRICATION

Lubricate the Jackshaft Assembly

A grease fitting is provided to lubricate the jackshaft assembly. Use a grease gun with au- tomotive type grease to lubricate the jackshaft assembly as shown in Figure 10.

Grease Fitting

Figure 10

Change Engine Oil

Change the engine oil when the engine is warm. For the proper oil capacity, see the en- gine manufacturer’s instructions.

7.Connect the spark plug wire to the spark plug.

1.Disconnect spark plug wire from the spark plug.

2.Remove the oil drain plug as shown in Figure 11.

3.Drain all the engine oil into a flat pan.

4.Install the oil drain plug. Make sure the oil drain plug is tight.

5.Remove the dipstick.

6.Fill the engine crankcase. DO NOT OVERFILL. For proper oil capacity, see the engine manufacturer’s instructions.

Oil Drain Plug

Figure 11

1739579

Page 15

Image 15

Hayter Mowers 407F manual LUBRICATION Lubricate the Jackshaft Assembly, Change Engine Oil, Maintenance

Contents

Code 407F POWERTRIMOWNER’S HANDBOOK ASSEMBLY TABLE OF CONTENTSLIMITED WARRANTY OPERATOR SAFETYHAYTER LIMITED LIMITED WARRANTYThe responsibility of the owner is to follow the instructions below OPERATOR SAFETYSAFETY PRECAUTIONS OWNER’S INFORMATIONOPERATOR SAFETY IV. ServiceII. Slope Operation III. Children12. Clean and replace safety and instruction decals as necessary OPERATOR SAFETYOPERATOR SAFETY Safety Warning PictorialsINTERNATIONAL PICTORIALS Control And Operating PictorialsREMOVE THE TRIMMER FROM CARTON ASSEMBLYCONTENTS OF LITERATURE PACK 1 - Warranty Card 1 - Safety Glasses 1 - Trimmer Line 2 SetsRAISE THE HANDLE ATTACH THE GUARDASSEMBLY Fill Fuel Tank With Petrol CHECKLISTENGINE PREPARATION Fill Crankcase With OilSTOP THE TRIMMER HEAD KNOW YOUR POWERTRIMOPERATION EYE PROTECTIONUSE THE PRIMER BUTTON USE THE TRIMMER HEADDRIVE LEVER USE THE THROTTLE CONTROLSTART THE ENGINE TRIMMER TIPSOPERATION Fill in dates as you MAINTENANCESERVICE RECORDS complete regular serviceLUBRICATION Lubricate the Jackshaft Assembly Change Engine OilMAINTENANCE ADJUST THE HEIGHT OF THE HANDLEBAR SPARK PLUGMAINTENANCE MAINTENANCE SERVICE AND ADJUSTMENTPROPER CARE OF TRIMMER LINE CHANGE TRIMMER LINESEngine REPLACE THE DRIVE BELTSTORAGE TrimmerCORRECTION TROUBLESHOOTING CHARTTROUBLE CAUSErunning TROUBLESHOOTING CHARTEngine overheats Engine will not stopEngine Power Rating Information SPECIFICATIONSthis Series engine Order Replacement Parts Repair Parts NOTE Unless noted otherwise POWERTRIM Code 407Fspecification chart Handle And WheelsQTY. DESCRIPTION POWERTRIM Code 407FHandle And Wheels REF NONOTE Unless noted otherwise POWERTRIM Code 407Fspecification chart Cutting Head And ShieldDESCRIPTION POWERTRIM Code 407FCutting Head And Shield REF NOScrew, 1/2 Torque Specification ChartHardware Identification & Torque Specifications Nut, 1/2”