6.Disconnect the front hanger (9) from the axle support. See illustration “F”.
7.Remove the mower drive belt (7) from the stack pulley (8). See illustration “G”.
8.(Figure 16) Disconnect the rubber strap (1) from the connector tube (3). Slide the con- nector tube (3) off the extension tube (8).
9.Pull the mower housing away from the right side of the unit.
10.To install the mower housing, reverse the above steps.
How To Replace The Fuse
If the fuse is blown, the engine will not start. Remove the fuse and replace with a 15 amp. automotive fuse.
Storage (over 30 days)
At the end of each year, prepare the unit for
storage as follows.
1.Drain the fuel from the carburettor and the fuel tank. Change the engine oil. See the en- gine manufacturer’s instructions.
2.Clean the unit.
3.Charge the battery. See “How To Charge The Battery”.
How To Order Replacement Parts
The replacement parts are shown either on the back pages of this Instruction Book or in a separate Parts List Book.
Use only manufacturer’s authorized or approved replacement parts. The letter placed on the end of the part number denotes the type of finish for the part, C for chrome, Z for zinc, a PA for purchased assembly. It is important that you include this when ordering a part. Do not use attachments or accessories not specifically
GB
recommended for this unit. In order to obtain proper replacement parts you must supply the model number of your mower (see nameplate).
Replacement parts are available from your local Hayter authorised dealer.
If you are unable to obtain parts or service in the manner outlined above, then contact:
HAYTER LIMITED, Service Department,
Spellbrook, Bishop’s Stortford,
Hertfordshire. CM23 4BU.
UK ONLY: Details of your local Hayter authorised dealer are contained in Yellow Pages or contact: Freephone 0800 616298.
When ordering the following information is required:
(1)The Model Number
(2)Serial Number
(3)Part Number
(4)Quantity
18 |
