ELECTRONIC MONITOR MODES
The
SpeedÑDisplays the number of repetitions you are performing per minute.
TimeÑDisplays the length of time you have exer- cised. Note: If you stop exercising for ten seconds or longer, the time mode will pause until you resume.
DistanceÑDisplays the total number of repetitions you have completed, up to Ò999.Ó The display will then reset to Ò0Ó and continue counting.
CaloriesÑDisplays the approximate number of Calories you have burned. Note: If the resistance is near the highest or lowest setting, the actual number of Calories you have burned will be slightly higher or lower than the number displayed.
ScanÑDisplays the speed, time, distance, and calo- ries modes, for approximately 5 seconds each,
in a repeating cycle.
DIAGRAM OF THE ELECTRONIC MONITOR
1
2
3 4
1.LCD displayÑDisplays all modes.
2.Mode indicatorsÑShow which mode is selected.
3.Mode buttonÑSelects all modes.
4.On/Reset buttonÑTurns the power on and resets all modes.
BATTERY INSTALLATION
Before the electronic monitor can be operated, two ÒAAÓ batteries must be installed. If you have not installed batteries, see assembly step 6 on page 7.
OPERATING THE ELECTRONIC MONITOR
1.To turn on the power, press the on/reset button or simply begin exercising on the AEROFLYER. The entire display will appear for two seconds. The electronic monitor will then be ready for operation.
2.Select one of the five modes:
Scan modeÑWhen the power is turned on, the scan mode will be selected automatically. The scan mode
can also be
selected by repeatedly
pressing the mode button. One mode indicator will
show that the scan mode
has been
selected, and a second mode indicator will show which mode is currently displayed.
Speed, time, distance, or calories modeÑ These modes can be individually selected by repeatedly
pressing the
mode button. The mode
indicators will show which mode has been
selected. (Make sure
that the scan
mode is not selected.) The modes will be selected in the following order: speed, time, distance, calories, scan.
3.The monitor has an
To reset the LCD display, press the on/reset button.
10