5.Push the Magnet Bracket (36) into the hole in the Pedal Frame (4).
Lubricate a Frame Axle (13). Attach the Pedal Frame (4) to the Main Frame (1) with the Frame Axle (13), two Rubber Washers (51), and two Axle Fasteners (56).
6.Attach the Left Side Shield (21) to the Seat Frame
(2) using three Fastener Bases (45) and three Fastener Pins (58). First, insert the Fastener Bases through the Side Shield and into the Seat Frame. Next, push the Fastener Pin (58) into the hole in each Fastener Base until it is flush with the Base.
Attach the Right Side Shield (22, not shown) in the same way.
7.While another person holds the Long Link Arm (10) and the Short Link Arm (11) in place, put two Plastic Washers (49) between them. Then, connect the Seat Swing Arm (5), the Long Link Arm (10), and the Short Link Arm (11) using an M8 x 1.375” Bolt (17) and an M8 Nylon Jam Nut (7).
8.Place the Seat (20) on the Frame (2). Slide the Seat Washer (38) onto the Seat Knob Bolt (43) and then tighten the Seat Knob (37) onto it.
Slide the Weight Bracket (8) onto the Seat Frame (2) so that it slants away from the AEROBIC RIDER 2. Align the holes in the Weight Bracket with the ones in the end of the Frame. Insert the M8 x 120mm Bolt (57) through the Weight Bracket and the Frame and secure it with an M8 Nylon Jam Nut (7).
5 | 56 |
|
|
| 1 |
| |
| 51 |
| |
|
|
| |
|
| ||
|
| 51 |
|
|
|
| 56 |
36 | Hole | 4 |
|
|
| ||
6 |
|
|
|
|
|
| 2 |
|
| 21 | 58 |
|
|
| 45 |
|
| 45 | |
|
|
| 58 |
7 |
|
|
|
|
|
| 5 |
|
| 17 | 7 |
|
| 10 | |
|
|
| |
|
| 49 |
|
|
|
| 11 |
8 |
|
|
|
|
|
| 20 |
|
| 7 | 8 |
| 43 |
| |
|
|
| |
| 2 |
|
|
|
| 38 | 57 |
|
| 37 |
|
6
