Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity used for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.


M6 Washer	M8 Washer		Torque Washer		M10 Split		M10 Nylon
(64)–2		(66)–2	(106)–2		Washer (57)–3		Locknut (89)–4
M4 x 16mm		M6 x 16mm Patch		M8 x 19mm Patch		M10 x 25mm Button
Screw (98)–4		Screw (76)–4		Screw (111)–2			Screw (96)–3
	M8 x 63mm Bolt Set (65)–2				M6 x 48mm Flat Head Screw (83)–4
			M10 x 105mm Carriage Bolt (25)–2
			M10 x 92mm Carriage Bolt (63)–2

1.Identify the Front Stabilizer (8), which has Wheels (109) attached to the front. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 92mm Carriage Bolts (63) and two M10 Nylon Locknuts (89).

While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame with two M10 x 105mm Carriage Bolts (not shown) and two M10 Nylon Locknuts (not shown).

1
	109
63
8	89
	89
	1

Healthrider HRE69940 manual Assembly

Models: HRE69940

ASSEMBLY