TROUBLESHOOTING AND MAINTENANCE
Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department
PROBLEMSOLUTION
1.The power does not turn on
a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 7). Use only a
b.Make sure that the key is fully inserted into the console.
c.Check the circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d.Check the on/off switch located on the frame near the power cord. The switch must be in the on posi- tion.
c
Tripped Reset
d
On
Position
2.The power turns off during use
a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in.
c.Remove the key from the console and then reinsert it.
d.Unplug the power cord, wait for five minutes, and then plug the power cord back in.
e.Make sure that the on/off switch is in the on position (see 1. d. above).
3.The walking belt slows when walked on
a.Use only a
b.If the walking belt is overtightened, tread-
mill performance may decrease and the b3–4”
walking belt may be permanently dam-
aged. Remove the key and UNPLUG THE POWER CORD. Using the included allen wrench, turn both rear roller adjustment
bolts counterclockwise 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift the edges of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
25
