Healthrider HRTL34306.1 manual

7.Set the Console Assembly (91) face-down on a soft surface to avoid scratching the Console Assembly. Hold the Right Handrail (33), which has a large hole in the location shown, near the Console.

Next, insert the console wire into the hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail.

Then, set the Right Handrail (33) on the Console Assembly (91). Make sure that no wires are pinched. Finger tighten a Crossbar Screw (85) with a Crossbar Star Washer (7) into the Right Handrail, and then start two Console Screws (10) into the Right Handrail. Tighten the

Crossbar Screw and then the two Console Screws; do not overtighten the Screws.

Attach the Left Handrail (not shown) to the Console Assembly (91) in the same way. Note: There are no wires on the left side.

8.See drawing 8a. Press the indicated tab and re- move the guard from the console wire with needlenose pliers. Discard the guard.

With the help of a second person, hold the Console Assembly (91) near the Right Upright (54).

Remove the colored tie from the Wire Harness (39). Connect the Wire Harness to the console wire. Make sure to connect the connectors properly (see drawing 8b). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-

NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and excess wire into the Right Upright (54).

7
	Console	85
	Wire
	Bracket	7	10
33	Large
	Hole
	91
8			8a

	Console
	Wire
91	Tab
	Guard
Console
Wire	8b
39
54	39

9. Attach the Console Assembly (91) to the Right	9	91
Upright (54) and the Left Upright (53) with four
four Handrail Bolts (8) and four Handrail Star
Washers (5). Make sure that no wires are
pinched. Start all four Handrail Bolts before
tightening them.
With the help of a second person, carefully lower
the Uprights (53, 54) to the floor.
		8	8
		5	5
		54	53
	9