If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor.
1.Remove the key from the console and unplug the power cord.
Remove the 3/4" Screw (23) and the Access Door (100) from the back of the Console Base (98).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base (98).
Hold the receiver so the small cylinder is ori- ented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (100) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (100) with the 3/4" Screw (23). Discard the other wires included with the re- ceiver.
|
| Wire | |
98 |
| Small | |
|
| Screws | |
100 |
|
| |
23 | A | Small | |
Cylinder | |||
|
|
11
