HOW TO TURN ON THE POWER
1 Plug in the power cord (see page 8).
2 | Locate the reset/off |
|
|
|
|
|
circuit breaker on the |
|
|
|
|
| |
| treadmill near the power |
| Reset |
|
|
|
|
|
|
|
| ||
| cord. Switch the circuit |
| Position |
|
|
|
| breaker to the reset |
|
|
|
|
|
|
|
|
|
|
| |
| position. |
|
|
|
|
|
|
|
|
|
|
|
Stand on the foot rails of the treadmill. Find the clip
3 attached to the key (see the drawing on page 9)
and slide the clip onto the waistband of your clothes. Next, make sure that the cord attached to the clip is routed under the Lightspeed bar, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps back- ward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1 Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is in- serted, the manual mode will be selected and the indicator on the
Manual Control button will light. If you have se-
lected a program, reselect the manual mode by pressing the Manual Control button.
3 Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the twelve Lightspeed buttons.
If the Start button or the Speed increase button is pressed, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in in- crements of 0.5 mph.
If one of the Lightspeed buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting. Indicators on the button that you press will flash while the speed of the walking belt is changing.
CAUTION: The Lightspeed bar is not intended to be used as a handlebar. If you hold the han- dlebar for support, you may unintentionally press one of the Lightspeed buttons, causing the speed of the walking belt to increase.
To stop the walking belt, press the Stop button or the space to the right of the Stop button. The time will begin to flash in the Pace/Time display. To restart the walking belt, press the Start button, the Speed increase button, or one of the twelve Lightspeed buttons.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 28).
4 Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the Incline increase and de- crease buttons. Each time a button is pressed,
the incline will change by
0.5%. To change the incline quickly, press one of the ten Quick Incline buttons.
Follow your progress with the matrix and the
5 displays.
The matrix—When the
manual mode or the iFIT.com mode is se- lected, the matrix will display a
dicators around the track
will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.
10
