Hearth and Home Technologies 6000TRS-CE manual Check the thermopile with a millivolt

Symptom	Possible Cause	Corrective Action
3. (Continued)		Check the thermopile with a millivolt
		meter. Take the reading at TH-TP&TP
		terminals of the gas valve. The meter
		should read 325 millivolts minimum,
		while holding the valve knob
		depressed in the pilot position, with
		the pilot lit, and the ON/OFF switch in
		the OFF position. Replace the faulty
		thermopile if the reading is below the
		specified minimum.
		With the pilot in the ON position,
		disconnect the thermopile leads from
		the valve. Take a reading at the
		thermopile leads. The reading should
		be 325 millivolts minimum. Replace
		the thermopile if the reading is below
		the minimum.
	c. Defective valve	Turn the valve knob to the ON position.
		Place the ON/OFF switch in the ON
		position. Check the millivolt meter at
		the thermopile terminals. The millivolt
		meter should read greater than 125mV
		If the reading is acceptable, and if the
		burner does not come on, replace the
		gas valve.
	d. Plugged burner	Check the burner orifice for stoppage.
	orifice	Remove stoppage.
	e. Wall switch or wires	Follow the corrective action in
		Symptom and Possible Cause 1. a.
	are defective
		above. Check the switch and wiring.
		Replace where defective.
4. Frequent pilot	a. Pilot flame may be	Clean and adjust the pilot flame for
		maximum flame impingement on
outage problem.	too high or too low,
		thermocouple. Follow lighting
	or blowing (high),
		instructions carefully.
	causing pilot safety
	to drop out

41