Hearth and Home Technologies 6000TRS-CE manual Placed in this Opening

42

Symptom	Possible Cause	Corrective Action
5. The pilot and main	a. No LP in the tank	Check the LP (propane) tank. Refill the
burner extinguish		fuel tank.
while in operation.	b. Inner flue pipe	Check for gas leaks.
	leaking exhaust
	gases back into the
	system
	c. Horizontal flue	The horizontal flue cap should slope
	improperly pitched	down only enough to prevent any water
		from entering the unit. The maximum
		downward slope is 0.6 cm.
	d. Glass too loose and	Tighten the corner.
	air tight packet leaks
	in corners after
	usage
	e. Bad thermopile or	Replace if necessary.
	thermocouple
	f. Improper flue cap	Check for proper installation and
	installation	freedom from debris or blockage.
6. Glass soots.	a. Flame impingement	Adjust the log set so that the flame
		does not excessively impinge on it.
	b. Improper venturi	Adjust the air shutter at the base of the
		burner.
	setting
		Inspect the opening at the base of the
	c. Debris around
		burner. NO MATERIAL SHOULD BE
	venturi	PLACED IN THIS OPENING.
7. Flame burns blue	a. Insufficient oxygen	Ensure that the flue cap is installed
and lifts off burner.	being supplied	properly and free of debris. Ensure that
		the flue system joints are tight and
		have no leaks.
		Ensure that no debris has been placed
		in the area at the base of, or in the area
		of, the air holes in the center of the
		base pan beneath the burner.
		Ensure that the glass is tightened
		properly on the unit, particularly on top
		corners.