R
3100-I ACT WOOD INSERT
INSTALLATION OF PANEL SET AND TRIM
Part No. | Description | Size | Part No. | Description | Size |
Large, Gold | Std, Nickel | ||||
|
|
| Large, Nickel |
Kit Includes: (2) Side Panels, left & right; (1) Panel Top & Fastener package; (2) Side Trim, left & right; (1) Trim Top & Fastener package.
Tools Needed: Powered Phillips head screw driver.
Attaching Panels to the Insert
1.Install the 2 side panels on the insert first, using the cage nuts already attached to the stove, pushing panels away from the insert to the maximum distance of the slot. See Figure 12A. (Note: The sides are interchangeable).
2. Put on the top panel and push straight back. Attach the top panel to the sides using the screws and the panel brackets found in the fasteners package. Now move the side panels inwards (toward insert) into position and tighten screws.
Assembling Trim
1.Place protective covering on surface to be used to assemble the trim pieces. Lay the trim face down.
2.Attach the 2 side trim pieces to the top trim at each corner using the “L” bracket included in fasteners package. Slide assembled trim over panel set. See Figure 12B.
View of “L” Bracket Installed
Panel brackets
Install sides and push out to maximum distance of slot.
Adjust position by sliding 
left or right after top is in
place.
Figure 12A | Figure 12B |
| DOOR HANDLE ASSEMBLY | ||
1. | Install washer on door handle shaft. |
|
|
2. | Slide door handle through door. |
| Door Cross Section |
|
|
| |
3. | Install second washer(s) as shown. | Latch Cam | (example) |
|
| ||
4. | Install key in groove. | Locknut |
|
5. | Align groove in latch cam with key; slide |
| |
|
| ||
| latch cam over shaft. |
|
|
6. | Install locknut. |
| Spring |
| Caution! Do not overtighten locknut. |
| |
|
| Handle | |
| Door handle needs to move smoothly. |
|
|
7. | Install spring handle turning counter- |
| Door Handle |
| clockwise to desired location on handle. |
| Spacing |
|
|
| Washers |
|
|
| Square Key |
Page 12 | September 1, 2008 | ||
