Hearth and Home Technologies 830-0381, 3100-I Zero Clearance Adjustable Trim SUPPORT, 2 to, See B

R

3100-I ACT WOOD INSERT

ZERO CLEARANCE ADJUSTABLE TRIM SUPPORT, 2” to 10”

Part No. 841-0990, size 9” x 45” and Part No. ADJSPT-12, size 12” x 50”

Included in Kit: (1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)

Tools Needed: Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves

EXPLODED VIEW OF SCISSORS

1.The 10 screws on each set of scissors will already be loose when shipped. See Figure 14A.

2.Expand scissors to desired height. Tighten screws to hold in place using Phillips Head screwdriver. See

Figure 14B.

3.Measure front and side trims to required height to cover scissors and mark pieces for cutting. Cut excess mate- rial from top of trim’s edge, not bottom. This edge will be sharp; wear gloves to prevent injury to your hands.

See Figure 14B.

4.Using sheet metal shears, cut trim along the marked edge. The cut edge fits under lip of top trim, so it allows for some variance in your straight edge.

5.The double-sided tape that holds front and side trims to scissors has a particularly powerful bonding adhe- sive. Adjustments are extremely difficult once trim has adhered to tape. Do a dry run first without removing paper from tape.

6.Place cut edge of trim under top lip and into position on scissors. Place side pieces on first and then front piece. The front piece overlaps side pieces. NOTE: The trim in the Flush Mount Kit is one piece.

7.Once you are satisfied with the positioning, remove trim and set aside.

8.Remove the paper from double-sided tape that is to accept trim side. Align side and then press hard against tape to secure side piece. Repeat for other side. Install front trim piece last.

9.There are 3 holes in the back flange of the top to secure it to the wall if necessary. Use the appropriate fastener for the type of wall material, i.e., brick, sheet- rock, etc.

NOTE: 3/8” ( 9.5mm) thick tile or like material can be cut to size and fit under lip of top trim edge for a decora- tive touch. See Figure 14C.

SCREWS ARE CIRCLED

DOUBLE-SIDED TAPE	DOUBLE-SIDED TAPE
	Figure 14A

EXPAND SCISSORS TO DESIRED HEIGH T

CUT TOP EDGE OF TRIM,

INSTALL FRONT TRIM LAST. NOT BOTTOM EDGE CORNERS OVERLAP SIDE

TRIM PIECES

Figure 14B

Decorative tile may

be installed

Figure 14C

Figure 14D

Page 14 250-6381D September 1, 2008