Hearth and Home Technologies DVP-FBHT installation instructions Installation

DVP-FBHT

Firebrick Termination Cap

- Installation Instructions -

These instructions should be used along

with the Cinch Pipe and

Termination Cap System instructions

included with this kit.

CAUTION

Sharp Edges

•Wear protective gloves and safety glasses during installation.

The DVP-FBHT is a horizontal firebrick termination cap with 4 inch telescoping flue (see Figure 1).

Included is the DVP-WS wall shield firestop with heat shield and one fastener pack.

WARNING

Fire Risk

Do NOT use this termination cap on vinyl siding.

Installation

1.Carefully remove cap from the packaging.

Note: Variation in the appearance of the termination cap color and surface are inherent and unique characteristics of the manufacturing process and are to be expected with this product. Such surface characteristics as chips, small cracks, and pits do not affect the product performance in any manner.

2.Frame the 12 inch by 10 inch opening in the wall by following the directions in the Cinch Pipe and Termination cap instructions. When housewrap or underlayment is used, the housewrap manufacturer’s instructions for flashing a penetration MUST be followed.

3.Install the interior wall shield firestop by following the instructions in the Cinch Pipe and Termination cap instructions.

Exterior finishing materials allowed ONLY above line.

WALL SHIELD
FIRESTOP	METAL	FIREBRICK
	BACKPLATE
		BOLT (3)
HEAT SHIELD		1 IN.

TELESCOPING

FLUE SECTION

Figure 1. DVP-FBHT

Printed in U.S.A. Copyright 2006
Hearth & Home Technologies, 20802 Kensington Boulevard, Lakeville, MN 55044	2084-900B 1/06
1