WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged vent system component.
•Modification of the vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
4.Install the telescoping flue section included with the cap on the last section of flue pipe.
WARNING
Fire Hazard
Impaired performance of appliance
• Telescoping flue section of termination cap MUST be used when connecting pipe section to termination cap.
•Maintain a
5.Remove the three bolts from the firebrick cap face to separate the firebrick part of the cap from the metal backplate (see Figure 1).
6.Slide the backplate, with the 8 inch collar on it, onto the flue pipe from the fireplace. For thinner wall construction, you may have to trim the heat shield on the metal backplate and interior wall shield firestop.
WARNING
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least
•Use pilot holes for screws.
•Screws must not exceed 1 inch long.
•Pipe may separate if not properly joined.
NOTE: The heat shield on the interior wall shield firestop and the heat shield on the metal backplate must overlap
7.Secure the backplate to the wall with four appropriate length screws from the hardware pack.
8.Seal the backplate to the housewrap or sheathing. Follow housewrap manufacturer’s instructions for sealing a penetration when applicable.
9.Slide the firebrick part of the cap onto the backplate by aligning the 5 inch collar with the 5 inch flue pipe coming from the fireplace. Slide the two pieces together until the firebrick part bottoms out on the backplate.
10.Replace the three bolts removed in step 2. DO NOT OVERTIGHTEN THE BOLTS.
Measure vertical |
| |
clearances from |
| |
this surface. |
| |
| Measure horizontal | |
| clearances from | |
| this surface. | |
1 in. | ||
(25) | ||
(182) | ||
| ||
14 in. |
| |
(356) |
| |
3/8 in. (9) | ||
| 1 in. (25) | |
| ||
| ||
| 12 in. | |
| (305) | |
Figure 2. |
|
2