4.2 INSTALLING THE BLOWER
Position the blower all the way to the rear and center in the fireplace. Pull the blower forward 1/8" to 1/4" from the back wall of the fireplace (Figure 3). Plug the blower cord into the blower receptacle FAN on the junction box. Attach the ground wire to the bottom of the junction box or to a good accessible metal grounded source. Note: You can attach this to the firebox leg.
METAL
STYLE
SENSOR
JUNCTIONSWITCH
BOX
“FAN”
RECEPTACLE
4.3INSTALLING THE SPEED CONTROL AND SENSOR SWITCH
1.Remove the knob and locknut from the variable speed control. Slide the control behind the fireplace wall, in the lower right front corner, with the stem sticking out of the
NOTE: Some models may have a separate mount- ing location on the base pan or valve bracket for mounting this speed control.
2. Slide the temperature sensor switch/bracket assembly |
onto the weld stud on the outside of the combustion cham- |
ber. Secure the bracket assembly with the wing nut pro- |
BLOWER
NOTE: SOME MODELS MAY HAVE A SEPARATE MOUNTING LOCATION ON THE BASE PAN OR VALVE BRACKET FOR MOUNTING THIS SPEED CONTROL
SPEED
CONTROL
vided. See Figure 4. |
NOTE: The weld stud is located either on the lower right side or the bottom of the combustion box.
TEMPERATURE
SENSOR SWITCH
1/8” TO 1/4” |
FIREPLACE |
WALL |
BLOWER |
POWER STRIP
STYLE
JUNCTION
BOX
BLOWER | SENSOR |
SWITCH |
“FAN” |
|
RECEPTACLE | SPEED |
| CONTROL |
FIGURE 3
WING
NUT
SPEED
CONTROL
FIGURE 4
NOTE: THE SWITCH/BRACKET ASSEMBLY MUST BE INSTALLED SO THAT THE SENSOR SWITCH IS TO- WARDS THE TOP OF THE UNIT.
3.Connect the variable speed control and the temperature sensor switch to the junction box with the wires provided. See Figure 5 for the wiring diagram that matches the style of junction box on the fireplace.
4.Turn the
2