METAL STYLE JUNCTION BOX |
| VARIABLE SPEED |
|
|
| NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED | |
|
| SWITCH | |
|
| ||
|
|
| WITH THE APPLIANCE MUST BE REPLACED, IT MUST |
|
|
| |
| BLK | BE REPLACED WITH TYPE 105O C RATED WIRE. |
BLK |
|
| |
| JUNCTION BOX |
| |
| BLK | BLOWER RECEPTACLE | |
|
| ||
| BLK | BLK | |
| BLK |
| |
BLK | WHT | WHT | |
| |||
| GROUND |
| |
TEMPERATURE | GRN | BLOWER | |
SENSOR SWITCH |
| ||
BLK | WHT | ||
| |||
| GROUND | ||
|
| ||
|
| WIRE | |
|
|
POWER STRIP STYLE JUNCTION BOX
VARIABLE
SPEED SWITCH
NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105O C RATED WIRE.
JUNCTION BOX
TEMPERATURE |
SENSOR SWITCH |
BLUE
FIGURE 5 Fan Wiring Diagram
5.0RECOMMENDED OPERATING PROCEDURES
Ignite the fire in the fireplace with the variable speed control switch in an "ON" position. The fan will automatically turn on when the temperature sensor switch closes at approxi- mately 110O F. Heated air should be delivered at the outlet grille. The fan will continue to operate after the fireplace is turned OFF until the sensor switch opens.
Various conditions (such as fireplace model, type of fire- place installation, outside air temperature vs. inside air tem- perature) can contribute to the length of the time the blower remains on after the fireplace is turned OFF. The blower can be turned off manually with the speed control switch.
WARNING: NEVER CONTACT BLOWER WHEEL (VANES) DURING BLOWER OPERATION.
6.0 MAINTENANCE
Periodically check the fireplace grilles and remove any dust, dirt or obstructions.
7.0REPLACEMENT PARTS AND CUSTOMER SERVICE
Replacement parts and service may be obtained through your dealer.
Hardware Bag: SRV107-570A
3