•This appliance must have a screen in place while the appliance is in operation and, unless other provisions for combustion air are provided, the screen shall have an opening for introduction of combustion air.

•Solid fuels shall not be burned in a fireplace where a decorative appliance is installed.

•If glass doors are present, the glass doors must be fully opened while appliance is in operation.

WARNING

Do NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

D. Appliance Certification

This appliance has been evaluated by Omni in accordance with the requirements of Ansi Z21.84-2004 Standard for Decorative Log Sets for Installation in Wood Burning Fire- places. Installation and the provisions for combustion and ventilation air must conform to the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the CSA B149.1, Natural Gas and Propane Installation Code.

E. Gas Supply Connection

A 3/8 in. flared fitting has been installed on the gas valve inlet at the factory. Ensure fittings are of the appropriate size and type on the gas line connection. If the tubing has to be cut to length be sure to use the proper cutting and flaring tool. Also, be careful not to crimp the tubing while bending. If the tubing becomes crimped, do not use for installation.

Gas resistant pipe compound must be used on all threaded male connections to ensure a tight seal.

F. Gas Pressure

Proper input pressures are required for optimum appliance performance. Gas line sizing requirements need to be made following NFPA51.

WARNING

Fire Risk

Explosion Risk

High pressure will damage valve.

•Disconnect gas supply piping BEFORE pressure testing gas line at test pressures above 1/2 psig.

•Close the manual shutoff valve BEFORE pressure testing gas line at test pressures equal to or less than 1/2 psig.

WARNING

Fire Risk

Explosion Risk

Verify inlet pressures.

•High pressure may cause overfire condition.

•Low pressure may cause explosion.

Install regulator upstream of valve if line pressure is greater than 1/2 psig.

•Gas Supply Pressure: Minimum inlet gas supply pressure must be 7.0 in. W.C. for natural gas. The gas line supplying the appliance must be sufficient size to furnish the appropriate supply pressure to the appliance while operating in the “High” setting.

•Pressure tap screws must be closed before turning gas on to the appliance.

•Gas Line Pressure Test: Perform pressure test according to state and local code (if pressure exceeds 1/2 in. psi (3.5 kPa)) before appliance is connected. Be sure to release air pressure from the gas line before connection is made to the appliance. Excessive pressure will damage the gas control and may cause a gas leak.

•Gas Leak Test: Make sure the gas connections are tight. Turn on the gas and coat each joint with a non-corrosive gas leak check solution. Air bubbles will form indicating any leaks. DO NOT USE A FLAME OR ANY TYPE OF IGNITION SOURCE TO CHECK FOR LEAKS. All leaks must be corrected before proceeding with installation.

•The appliance must only be installed in a solid-fuel burning fireplace with the flue damper clamped open according to Tables 1 and 2. The fireplace must be constructed of non-combustible material.

•The minimum permanent free opening (in square inches) that must be provided by the fireplace chimney or damper to vent the flue gases is provided in Tables 1 and 2. If the free opening is smaller than the specified area, do not use this appliance.

•The damper must be removed or fixed in a manner in which will secure it open. Some jurisdictions require the damper to be removed or permanently welded fully open. Check with state and local codes.

•Be sure that the chimney is completely unobstructed to ensure proper ventilation of flue gases including carbon monoxide (CO). CO (a poisonous gas) is tasteless, odorless, colorless and undetectable without proper equipment.

•Refer to Table 3 to determine minimum fireplace opening requirements before proceeding.

Hearth & Home Technologies • Grand Oak Match Light Gas Log Sets • 4004-300 Rev F • 11/2011

Page 3 Page 5
Page 4
Image 4
Hearth and Home Technologies GO324MTCH, GO318MTCH, GO330MTCH Appliance Certification, Gas Supply Connection, Gas Pressure
Page 3 Page 5

GO330MTCH, GO324MTCH, GO318MTCH specifications

Hearth and Home Technologies offers a robust lineup of gas fireplaces, including the GO324MTCH, GO318MTCH, and GO330MTCH models. These fireplaces are designed to enhance the ambiance of any home while providing efficient heating and modern features that prioritize safety and user experience.

The GO324MTCH model is a standout with its contemporary design and large viewing area. It is equipped with a multi-function remote control, making it easy to adjust flames and heat settings from across the room. This model showcases a realistic log set that mimics the look of real wood, providing an inviting atmosphere without the hassle of traditional wood-burning fireplaces. Additionally, variable flame height can be adjusted to fit the ambiance you desire, whether it's a soft glow for a cozy evening or a more robust fire for gatherings.

Moving to the GO318MTCH, this model emphasizes versatility with its compact size and customizable options. It comes with optional decorative media, allowing homeowners to personalize their fireplace to match their interior decor. The GO318MTCH features a simple yet elegant design, which makes it a perfect fit for smaller spaces without compromising on style. Advanced safety features, including an automatic shut-off, ensure peace of mind while enjoying the warmth of the fire.

The GO330MTCH model takes efficiency to another level with its innovative technology that maximizes heat output while minimizing gas consumption. This fireplace is designed for those who prioritize energy efficiency and sustainability without sacrificing aesthetics. Featuring a sleek, linear design, it serves as a striking focal point in any room. The adjustable LED lighting adds a modern twist and allows users to create the perfect mood for any occasion.

All three models utilize direct vent technology, ensuring that they can be installed in a variety of spaces without the need for a traditional chimney. This feature not only broadens installation possibilities but also enhances the efficiency of heat delivery. With easy-to-use controls and smart home integration options, Hearth and Home Technologies' GO series of fireplaces offers an appealing blend of convenience, beauty, and functionality. Whether you're looking for a centerpiece for your living room or a supplemental heating source, these models are equipped to meet diverse needs while adding a touch of elegance to your home.
Top Page Image Contents