H. Inspect the Appliance and Components
•Remove the contents from the carton labeled “Burner”. Attached to the burner are tags identifying the manufacturer name, serial number, model number (including gas log size), BTU ratings, gas type, etc.
•Review the attached tags before proceeding. Ensure that all minimum fireplace dimension requirements are achieved using Table 3. See Figure 1. Ensure the gas type provided in the fireplace coincide with the gas type marked on the tag.
Figure 4 Placing Vermiculite
.Pour vermiculite over the sand in the pans until they are full. See Figure 4.
Note: For best results, do not pack down the rock wool. The placement of rock wool can have an effect on flame pattern and may need to be adjusted to achieve a desired appearance.
Figure 1 Measure Firebox
•The burner is assembled with the controls installed at the factory and is designed to connect one end of the 3/8 in. supply line before placing inside the fireplace. Ensure the
connection is tightened using a 3/4 in. wrench. | Figure 5 | Placing Rock Wool |
|
|
•Place the burner towards the rear and center of the fireplace and connect to the gas line. Follow instructions
in “F. Gas Pressure” to check for gas leaks. | • Lightly place |
| of the sand and vermiculite to achieve a glowing ember |
| effect. See Figure 5. |
I. For Natural Gas Installation
•Pour sand into the burner pans to the point where the burner pipe is covered. See Figure 3. Level the sand from right to left to ensure an even flame pattern. At this point the pan should be half full.
Figure 3 | Sand |
•Remove the Platinum Bright Embers™ from the package. For optimum performance peel each piece apart in layers and lightly place on top of the vermiculite and rock wool where the flame is blue. This will achieve the desired realism.
•The gas burns at the point of the least resistance. In case of an uneven flame pattern it may be necessary to adjust the materials in the pans (using an object such as a screwdriver) to achieve the desired effect.
•Place desired amount of lava granules on the floor of the fireplace. DO NOT ALLOW THE GRANULES TO COME IN CONTACT WITH THE FLAMES. (Lava granules may contain moisture which, when heating, may cause it to pop out during installation and
•Place logs. See Sections L Thru S.
•Place accent logs around burner on floor of fireplace.
Hearth & Home Technologies • Grand Oak Match Light Gas Log Sets •