RHW-41/RHW-47 INSTALLATION INSTRUCTIONS

A. LISTINGS AND CODE APPROVALS

This fireplace system has been tested and listed in accordance with UL127 and ULC-S610 standards, and has been listed by Underwriters Laboratories Inc. for installation and operation in the United States and Canada as described in this manual.

This fireplace has been tested and listed for use with the optional components listed on page 5. These optional components may be purchased separately and installed at a later date. However, installation of an outside air kit will require significant reconstruction, and should be installed at the time of the initial fireplace installation.

Check with your local building code agency prior to installing this fireplace to ensure compliance with local codes, including the need for permits and follow-up inspections. If you need assistance during installation, please contact your local dealer or the Heat-N-Glo Technical Services Department, Hearth & Home Technologies Inc., 1-888-427-3973.

Heat-N-Glo®is a registered trademark of Hearth & Home Technologies Inc.

WARNING!

This fireplace and its components are designed to be installed and operated as a system. Any alteration to or substitution for items in this system, unless allowed by these installation instructions, will void the Underwrit- ers Laboratories listing and may void the product warranty. It may also create a hazardous installation. Read through these instructions thoroughly before starting your installation and follow them carefully throughout your project.

B. DESCRIPTION OF THE FIREPLACE SYSTEM

1.The Heat-N-Glo fireplace system consists of the following:

a.Fireplace/Integral Grate

b.Refractory

c.Chimney Termination Cap

d.Chimney System

e.Hearth Extension

2.Optional Components Include:

a.Glass Doors

b.Chimney Air Kit

c.Outside Combustion Air System

Note: Illustrations used throughout these instructions reflect “typical installations” and are for design purposes only. Actual installation may vary slightly due to individual design preferences. However, minimum and maximum clearances must be maintained at all times.

The illustrations and diagrams used throughout these installation instructions are not drawn to scale.

Figure 1 - Typical Fireplace System

4

26022 Rev i

08/04

Page 4
Image 4
Hearth and Home Technologies RHW-47, RHW-41 Listings and Code Approvals, Description of the Fireplace System