Hearth and Home Technologies SFE-CDLB3530PP Remote Control Initialization, Control Usage

3 OPERATING INSTRUCTIONS

Ensure the appliance is connected to a properly grounded electrical outlet on a minimum 15 AMP circuit. If a new outlet is required, it should be installed by a qualified electrician according to applicable building codes.

A. Remote Control

Note: If the fireplace does not respond to the hand held control see “Remote Control Initialization” below.

This equipment has been tested and found to comply with the limits for class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installa- tion. This equipment generates and uses, and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Re-orient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Learn Button

FLAMES

HEATER

B. Remote Control Initialization

This procedure is required only when the unit is installed or the transmitter is replaced and is not affected by the loss of power.

•Ensure that power is supplied through main service panel.

•Place fresh batteries in the transmitter.

•Access the LEARN button by removing the front screen.

•Press and hold down the learn button. You will hear a beep.

•Press a button on the hand-held transmitter.

•Release the learn button when you hear the long beep.

•This completes the remote control receiver/transmitter initialization.

C. Control Usage

The controls operate the fireplace modes.

•The flame effect and backlog/embers are turned ON/OFF by alternate action of the FLAME button on the remote transmitter.

•The heater/blower and front embers are turned ON/OFF by alternate action of the HEATER button on the remote transmitter.

•The optional wall FLAME switch provides manual operation (ON/OFF) of the flame effect.

•The optional wall HEAT switch controls the front embers and activates the optional remote wall thermostat.

•Set the thermostat to the desired room temperature. The optional wall switches/thermostat are in parallel with the remote control relays. The wall switches MUST be OFF for the Remote Transmitter to control the fireplace.

Note: While the heater is ON the embers in front will glow. Ensure the heater is OFF when unattended.

6 Hearth & Home Technologies Inc. • Plug & Play • 4050-317 Rev A • 04/08