2

Assembly and Installation
To fully enjoy your new range, it is important that you read this booklet thoroughly.
Note:
Please check for any damage that may have occurred during shipping. In the unlikely event that you find any shipping
damage, inform your dealer immediately!

Caution when unpacking:

Lift the range by the bottom skirt, do not lift by nickel trim.

Unpacking:

Note: to avoid injury, please wear safety equipement, glasses and gloves, while you are unpacking your new range.
1) Unscrew the 12 screws that hold the crate onto the skid. There are 12 along the bottom and 4 along the top.
2) After the screws have been removed, carefully lift the crate over the stove and set it aside.
3) Next with a pair of tin sips cut the metal banding that holds the stove into place.Caution metal banding is under tension!
4) Carefully remove the metal banding, the 2 boards that where under the banding and the cardbord cap and styrofoam.
5) You are now ready to remove the range from the skid
For 30" units have one person at each end stand beside the skid and carefully lift the range by the bottom skirt, and a third
person pull the skid out from underneath the range. Slowly set the range down on the floor, bending you knee's not your
back!
For 48" units units have one person at each end and one side, stand beside the skid and carefully lift the range by the bottom
skirt, and a fourth person pull the skid out from underneath the range. Slowly set the range down on the floor, bending your
knee's not your back!
6) Finish unpacking the range removing packing tape around the doors and in the oven.
Both 30" and 48" Ranges consist of two main parts:The Range Body, and
The Cabinet / Exhaust Hood
Tools required for assembly: - Phillips/Robertson Screwdriver
- 5/16" ( 8 mm) wrench or crescent wrench

Gliders:

The teflon glider should
extend
beyond the bottom of the leg by approximately
1/8"-1/4". Adjusting levelling bolts in too far will cause the leg to drag on the
floor potentially causing damage to flooring. (see figure 1). Check that gliders
and floor are free of any debris, this will ensure you do not scratch your floor. Teflon Glider
1/8"- 1/4"

Assembly of Exhaust Hood to Range

See the manual entitled "Cabinet Installation Instructions
for Gas, Electric, Combination and Wood Stoves" which
is included with the cabinet .
(DO NOT REST CLOSET CORNER BRACKETS ON
PORCELAIN SURFACE, DAMAGE TO SURFACE
MAY OCCUR)
Figure 1
Figure 2
You must have a qualified electrician connect the new range to be sure all electrical codes and rules are
observed except when range is equipped with a cord and plug