Heat & Glo LifeStyle 6000TV-OAK-IPI For Intermittent Pilot Ignition IPI Wiring Volt Transformer

For Intermittent Pilot Ignition (IPI) Wiring

Î3 Volt Transformer

This appliance comes with a 3 volt transformer. The trans- former plugs into the junction box and the two leads plug into the green control module (see Figure 12).

Appliance Requirements

This appliance requires that 110-120 VAC be wired to the junction box included in the manual bag assembly. Maintain correct polarity when wiring the junction box.

The junction box is installed by sliding one tab of the box through the slot on the lower right side of the outer wrap and driving a screw through the other tab into the pilot hole on the outer wrap.

Operation using Battery Power

This fireplace has an optional battery operation. The sys- tem is fully functional with the use of two “D” size batteries without ordinary 110-120 VAC power.

Wiring to the battery pack should be left disconnected in order to conserve battery life. In the case of a loss of power,

simply connect red and black wire leads to activate battery power (connect red to red, black to black). The fireplace can be used as necessary. Once power (110 VAC) is re- stored, disconnect red and black wire leads to extend bat- tery life.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the fireplace junction box.

Wall Switch

Position the wall switch in the desired position on the wall. An assembly of 18 ft of 20 AWG is provided with the fireplace to connect the wall switch to the appliance. Instead of the supplied assembly, wire with a length of 25 ft or less and a gauge of 20 AWG through 14AWG is acceptable. The wire needs a jacket with a temperature rating of 140oF (60oC) or higher. At the appliance connect the wire to the ON/OFF switch pigtails.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERA- TION. VERIFY PROPER OPERATION AFTER SERVICING.

	TRANSFORMER OUTLET
PLUG-IN
3V TRANSFORMER
LOW VOLTAGE		FLAME SPARKER /
SEE NOTE 1
		SENSOR
IGNITION
MODULE
(3V)
		OPTIONAL
		BATTERY
		BACK-UP
ON/OFF
WALL SWITCH
VALVE		LOW VOLTAGE
		SEE NOTE 1
		REMOTE
NEUTRAL	GROUND	CONTROL
		HOT

NOTE 1: Ignition module, valve, pilot and wall switch operate on 3 volts. 120 VAC is required at junction box unless equipped with battery back-up.

	FAN
		IGNITION MODULE 3 VAC		INTERMITTENT PILOT IGNITOR
5		5
4		4		I
	REM/AUX
3		3
2		2
1	TRANS	1		S
HOT		NEUTRAL
		PLUG-IN
				WHITE
TRANSFORMER				(SENSOR)
	3 VAC
				ORANGE
				(IGNITOR)
		OPTIONAL BATTERY PACK		GROUND TO
				FIREPLACE
				CHASSIS
		BLACK		GREEN
		RED		ORANGE
			N
		BROWN	W
			O
			R
		TEMP SENSOR	B

VALVE

Figure 12. Intermittent Ignition (IPI) Wiring Diagram

Heat & Glo • 6000TV-OAK, 6000TV-OAK-IPI • 384-900 Rev. N • 11/05 17