Heat & Glo LifeStyle GEM36 manual Installing the Vent System, A. Vent System Approvals

Step 3. Installing the Vent System

A. Vent System Approvals

These models are approved to use DVP-series direct vent pipe components and terminations (see Figures 4 and 5). Approved vent system components are labeled for identifi- cation. This pipe is tested and listed as an approved com- ponent of the fireplace. The pipe is tested to be run inside an enclosed wall. There is no requirement for inspection openings at each joint within the wall. There is no required pitch for horizontal vent runs. NO OTHER VENTING SYS-

TEMS OR COMPONENTS MAY BE USED.

Detailed installation instructions are included with each vent termination kit and should be used in conjunction with this Installers Guide.

The flame and ember appearance may vary based on the type of fuel burned and the venting configuration used.

Identifying Vent Components

The vent systems installed on this gas fireplace may in- clude one, two, or three 90° elbow assemblies. The rela- tionships of vertical rise to horizontal run in vent configura- tions using 90° elbows MUST BE strictly adhered to. The rise to run relationships are shown in the venting drawings and tables. Refer to the diagrams on the next several pages.

NOTE: Two 45° elbows may be used in place of one 90° elbow. Rise to run ratios in the vent system must be followed if 45° elbows are used.

		VERTICAL			STORM COLLAR
		TERMINATION
					ROOF FLASHING
		HORIZONTAL
		TERMINATION
			WALL FIRESTOP
					PIPE LENGTH
			90 DEGREE	CEILING
			ELBOW
Î		Terminations Kits		FIRESTOP
	PVK-80	DVP-TVHW	DVP-TRAP
			SERIES
Figure 5.	Vent System Components and Termination Kits
		Heat & Glo • GEM36 • 370-900 Rev. O • 2/05			13