7Maintenance and Servicing the Fireplace
WARNING
Shock Risk
Burn Risk
Cleaning, performing maintenance or moving this electric stove without disconnecting power and allowing the stove to cool could create a shock or burn hazard.
•Turn controls to “OFF”.
•Remove plug from outlet or turn off the circuit breaker to the stove.
A. Cleaning Firebox and Control Compart- ment
•Turn the appliance off and disconnect the power cord from the outlet.
•Allow the appliance to cool before cleaning.
•Remove the top of the appliance by grasping the top on both sides and lifting up.
•Remove the heater system. See Figure 7.1. Rest it on top of the appliance so it does not fall.
•Remove the firebox top to access the log area.
•Replace all parts after cleaning has been completed.
•Plug in power cord.
B. Cleaning Glass Doors and Back Glass
The glass is cleaned in the factory during the assembly pro- cess. During shipment, installation, handling, etc. the glass surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a good quality household glass cleaner. The glass should be completely dried with a lint free cloth or paper towel.
In the event of glass breakage, vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM IF PIECES ARE HOT! Replace glass with only a glass panel ordered direct or through your local distributor. Never use substitute mate- rial. Only fully tempered soda lime safety glass may be used on this appliance.
Figure 7.1 Remove the Heater System |
10 | Heat & Glo • TiaraE• |
