Heat & Glo LifeStyle TiaraE 4035-822 manual C. Replacing the Light Bulbs, Burn Risk

C. Replacing the Light Bulbs

CAUTION

Burn Risk

Light bulbs are hot during operation of the stove.

•Allow bulbs to cool at least five minutes before touching them.

The light bulbs need to be replaced when the flame and/or ember bed is dark on one side. Replace the bulbs with 75 watt halogen bulbs with mini-candelabra base. Do not exceed 75 watts per bulb. Light bulbs can be purchased at a local hardware or lighting store, online or by phone. To order online, log onto www.lite-house.com or call 1-800-838-0977. We recommend you use Sylvania model 75Q/CL/MC/RP or Satco® model S3157.

•Turn off the circuit breaker or unplug the stove before replacing the light bulbs.

•Light bulb access is on the bottom front of the stove.

•Locate and remove the three screws. See Figures 7.2 and 7.3.

•Lower the cover plate to access the light bulbs.

•Carefully remove the burned out bulb from the light socket. Place the new bulb in the socket. Follow directions on the light bulb package for handling requirements.

•Reinstall the cover plate. Make sure all wires are back inside the stove.

•Reinstall the three screws removed earlier.

•Plug the stove’s power cord into the electrical outlet and turn the switch to “ON”.

CAUTION

Handle glass assembly with care.

When cleaning glass door:

•Avoid striking, scratching or slamming glass.

•Do NOT use abrasive cleaners.

•Do NOT clean glass when it is hot.

Remove these three screws.

(front)

Do not remove	Bulb Access Plate
these four screws.

(Bottom of stove.)

(back)

Figure 7.2 Screws on Bulb Access Plate

BulbsSockets

Figure 7.3 Replacing the Bulbs

Heat & Glo • TiaraE• 4035-822 Rev F • 01/05 11