Heat Controller BG-123A, BG-81A, BG-101A service manual Electrical Parts, Compressor, Capacitor

2.2.3 SHROUD

1.Remove the fan. (Refer to section 2.2.2)

2.Remove the shroud. (See Fig. 9)

3.Re-install the components by referring to the removal procedures, above.

2.3 ELECTRICAL PARTS

2.3.1 MOTOR

1.Remove the cabinet. (Refer to section 2.1.2)

2.Remove the clamp cord and disconnect the wire housing in control box. (Refer to section 2.1.3)

3.Remove the turbo fan. (Refer to section 2.2.2)

4.Remove the fan. (Refer to section 2.2.2)

5.Remove the 4 or 2 screws which fasten the motor. (See Fig. 10)

6.Remove the motor.

7.Re-install the components by referring to the removal procedures, above.

2.3.2 COMPRESSOR

1.Remove the cabinet. (Refer to section 2.1.2)

2.Discharge the refrigerant system using a FreonTM Recovery System.

If there is no valve to attach the recovery system to, install one (such as a WATCO A-1) before venting the FreonTM . Leave the valve in place after servicing the system.

3.Disconnect the 3 leads from the compressor.

4.After purging the unit completely, unbraze the suction and discharge tubes at the compressor connections.

5.Remove the 3 nuts and the 3 washers which fasten the compressor. (See Fig. 11)

6.Remove the compressor.

7.Re-install the components by referring to the removal procedures, above.

2.3.3 CAPACITOR

1.Remove the control box. (Refer to section 2.1.3)

2.Remove the 1 screw

3.Open the control box

4.Disconnect all the leads on the capacitor terminals.

5.Re-install the components by referring to the removal procedures, above.

Figure 9

Figure 10

Figure 11

	Coolrg
	Ene	y
	Saver
	Fan
			F1
			F3F2 MEDLOW
	DE	Timer	HIGH
MO			'F
			TEMP
		TIMER
			FAN
			SPEED
			POWER

Figure 12

—7—