Heat Controller CD-121J Importantsafety Instructions, Donotuseanextensioncordoranadapterplug

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual

IMPORTANT￿SAFETY INSTRUCTIONS

NOTE For￿some￿models,￿the￿power

supply￿cord￿with￿this￿air￿conditioner

contains￿a￿current￿detection￿device

designed￿to￿reduce￿the￿risk￿of￿fire.

￿	￿t ￿t ￿ ction,￿
Please refer to thesection “Operation
	,

of￿Currentt￿Device”￿fforr￿ detailsils.

In￿the￿event￿that￿the￿power￿supply

cord￿is￿damaged,￿it￿cannot￿be repaired-it￿must￿be￿replaced￿with￿a cord￿from￿the￿Product￿Manufacturer.

Do￿not,￿under￿any

circumstances,￿cut,

remove,￿or￿bypass

the￿grounding￿prong.

Power￿supply￿cord

with￿3-prong￿grounding￿plug and￿current￿detection￿device

WARNING For￿your￿safety

Do￿not￿store￿or￿use￿gasoline￿or￿other￿flammable￿vapors￿and￿liquids￿in

the￿vicinity￿￿of￿this￿or￿any￿other￿appliance.

Avoid￿fire￿hazard￿or￿electric￿shock.￿Do￿not￿use￿an￿extension￿cord￿or￿an

adaptor￿plug.￿Do￿not￿remove￿any￿prong￿from￿the￿power￿cord.

WARNING Electrical￿Infor mation

Be￿sure￿the￿electrical￿service￿is￿adequate￿for￿the￿model￿you￿have chosen. This￿information￿can￿be￿found￿on￿the￿serial￿plate,￿which is￿￿located￿on￿the￿side￿of￿the￿cabinet￿and￿behind￿the￿grille.

Be￿sure￿the￿air￿conditioner￿is￿properly￿grounded. To￿minimize shock￿and￿fire￿hazards,￿proper￿grounding￿is￿important. The￿power cord￿is￿equipped￿with￿a￿three-prong￿grounding￿plug￿for￿protection against￿shock￿hazards. Your￿air￿conditioner￿must￿be￿used￿in￿a￿properly￿grounded￿wall receptacle.￿If￿the￿wall￿receptacle￿you￿intend￿to￿use￿is￿not￿adequately grounded￿or￿protected￿by￿a￿time￿delay￿fuse￿or￿circuit￿breaker, have￿a￿qualified￿electrician￿install￿the￿proper￿receptacle. Ensure￿the￿receptacle￿is￿accessible￿after￿the￿unit￿installation. Do￿not￿run￿air￿conditioner￿without￿side￿protective￿cover￿in￿place. This￿could￿result￿in￿mechanical￿damage￿within￿the￿air￿conditioner.

Do￿not￿use￿an￿extension￿cord￿or￿an￿adapter￿plug.

Operation￿of Current￿Device

The￿power￿supply￿cord￿contains￿a￿current￿device￿that￿senses￿damage￿to￿the￿power￿cord. To￿test￿your￿power supply￿cord￿do￿the￿following:

		1.￿Plug￿in￿the Air￿Conditioner.
Plug￿in￿&		2. The￿power￿supply￿cord￿will￿have TWO￿buttons￿on￿the￿plug￿head.
press￿RESET		Press￿the TEST button,￿you￿will￿notice￿a￿￿click￿as￿the￿RESET
		button￿pops￿out.
	TEST	3.￿Press￿the￿RESET button,￿again￿you￿will￿notice￿a￿click￿as￿the￿button
		engages.
	RESET	4. The￿power￿supply￿cord￿is￿now￿supplying￿electricity￿to￿the￿unit.
		(On￿some￿products￿this￿it￿also￿indicated￿by￿a￿light￿on￿the￿plug￿head.)

NOTE:￿Some￿plugs￿have

buttons￿on￿the￿top.

NOTES:

Do￿not￿use￿this￿device￿to￿turn￿the￿unit￿on￿or￿off. Always￿make￿sure￿the￿RESET button￿is￿pushed￿in￿for￿correct￿operation. The￿power￿supply￿must￿be￿replaced￿if￿it￿fails￿reset￿when￿either￿the TEST button￿is￿pushed,￿or￿it￿cannot￿be reset. A new￿one￿can￿be￿obtained￿from￿the￿product￿manufacturer. If￿power￿supply￿cord￿is￿damaged,￿it￿cannot￿be￿repaired.￿It￿MUST be￿replaced￿by￿one obtained￿from￿the

product￿manufacturer.

4