Black & Decker BD200MTBR, BD200TMT Symbols, Environmental Safety, Cleaning and Disposal

2.A dust mask or respirator should be worn by all persons entering the work area. The filter should be replaced daily or whenever the wearer has difficulty breathing. See your local hardware store for the proper N.I.O.S.H. approved dust mask.

3.NO EATING, DRINKING or SMOKING should be done in the work area to prevent ingesting contaminated paint particles. Workers should wash and clean up BEFORE eating, drinking or smoking. Articles of food, drink, or smoking should not be left in the work area where dust would settle on them.

ENVIRONMENTAL SAFETY

1. Paint should be removed in such a manner as to minimize the amount of dust generated.

2. Areas where paint removal is occurring should be sealed with plastic sheeting of 4 mils thickness.

3. Sanding should be done in a manner to reduce tracking of paint dust outside the work area.

Cleaning and Disposal

1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding project. Vacuum filter bags should be changed frequently.

2. Plastic drop cloths should be gathered up and disposed of along with any dust chips or other removal debris. They should be placed in sealed refuse receptacles and disposed of through regular trash pick-up procedures. During clean up, children and pregnant women should be kept away from the immediate work area.

3. All toys, washable furniture and utensils used by children should be washed thoroughly before being used again.

Symbols

•The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V		volts	A		amperes
Hz		hertz	W		watts
min		minutes	no		alternating current
		direct current			no load speed
		Class I Construction			earthing terminal
	.................			..................
		(grounded)		.................	safety alert symbol
	.................	Class II Construction	opm		oscillations per minute
		(double insulated)

•When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

			Minimum Gauge for Cord Sets
Volts			0-25	Total Length of Cord in Feet
120V				26-50	51-100	101-150
240V			(0-7,6m)	(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
			0-50	51-100	101-200	201-300
			(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating				American Wire Gauge
More		Not more
Than	-	Than	18	16	16	14
0		6
6	-	10	18	16	14	12
10	-	12	16	16	14	12
12	-	16	14	12	Not Recommended

5