Troubleshooting
Problem | Possible Cause | Possible Solution |
• Unit will not start. | • Cord not plugged in. | • Plug tool into an |
working | • Circuit fuse is blown. | outlet. |
| • Replace circuit fuse. (If | |
|
| the product repeatedly |
|
| causes the circuit fuse to |
|
| blow, discontinue use |
|
| immediately and have |
|
| it serviced at a Black & |
|
| Decker service center or |
| • Circuit breaker is tripped. | authorized servicer.) |
| • Reset circuit breaker. | |
|
| (If the product |
|
| repeatedly causes the |
|
| circuit breaker to trip, |
|
| discontinue use |
|
| immediately and have |
|
| it serviced at a Black & |
|
| Decker service center or |
| • Cord or switch is damaged. | authorized servicer.) |
| • Have cord or switch | |
|
| replaced at a Black & |
|
| Decker service center or |
|
| authorized servicer.) |
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
Accessories
Recommended accessories for use with your tool are listed on page 12 and 13 and are available from your local dealer or authorized service center. In addition to Black & Decker ® accessories, your oscillating tool will also accept Porter Cable ® and Stanley FatMax ® oscillating tool accessories. If you need assistance regarding accessories, please call:
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
Service Information
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under
10
