Installation & Operation | Radiant Infrared Heater | Heat Controller |
|
|
|
WARNINGS
This electric appliance produces infrared heat, and failure to follow warnings and instructions can cause a fire, electric shock, or injury.
This heater is designed for outdoor commercial use only.
READ AND SAVE THESE INSTRUCTIONS!
WARNING |
| WARNING |
FIRE OR EXPLOSION HAZARD |
| PERSONAL INJURY |
|
|
|
•Failure to follow safety warnings exactly could result in serious injury or property damage.
•Do not use gasoline or other flammable vapors or liquids, including aerosol cans, in the vicinity of this heater while it is operating.
•Do not store or use any of the following flammable materials on or near the heater, or allow them to come in contact with the unit: rags, fabric, spray or aerosol cans, cleaning compounds, plastics
or plastic containers, paper products, gasoline, kerosene, lighter fluid.
•Do not install the heater close to furniture, curtains or other flammable items. Allow at least 6 feet (1.8 meters) between all sides of the heater and flammable items.
•Do not cover or otherwise obstruct the heater.
•Do not use heater without wire guard in place.
WARNING
PERSONAL INJURY HAZARD
•Do not touch the heater during operation. Burn or scald injury could result. The casing and components are extremely hot during operation.
•Keep children away from the heater. Never leave an unsupervised child near the heater.
•Because of injury risk, the heater should be operated only by individuals knowledgeable about the operation and familiar with the warnings and cautions listed in this manual.
•Because of injury risk, this heater is not intended for use by persons with reduced physical, sensory or mental capabilities.
•Heater is not for use in bathrooms, laundry areas or other locations where unit could fall into a body of water.
•To avoid property damage, personal injury or death due to electrical shock, do not service the unit without first turning the unit OFF and disconnecting the wired circuits from the main power supply.
•Allow adequate time for the unit to cool down.
•Service must be performed only by a qualfied service technician.
•Do not use the heater if the power cord is damaged. Contact an authorized servicer or qualified electrician to replace the cord prior to use.
•Do not use heater if it has been dropped or dam- aged in any way, until it has been inspected by an authorized service facility.
•When cleaning heater or replacing emitter, dis- connect wired circuits from the power supply. Be sure heater and/or emitter is cool before handling.
WARNING
INSTALLATION & USE
To avoid property damage, personal injury or death due to electrical shock, follow all instructions in this Installation and Operation manual.
•Specified minimum clearances from front, sides, bottom and back of unit must be met. Failure to meet clearance minimums can result in fire.
•Heater must be installed by a certified electrican and must adhere to all local, state and national electric codes (NEC).
•Heater must be grounded and hard wired.
•Keep the power cable away from body of heater. Do not use heater if power cord is damaged.
•Do not insert or allow foreign objects to enter any of the heater openings. Electrical shock could result.
•Never leave the heater unattended while it is operating.
2
