Heat Controller | Glass Panel Heater | Owner’s Manual |
|
|
|
OPERATION
POWER SWITCH
The power switch and control panel are located on the right side of the heater enclosure.
The LED display shows in the upper right corner of the glass panel on the front of the heater.
CONTROL
PANEL
LED
DISPLAY
•MODE BUTTON: There are four modes: LO, HI, AUTO, and STANDBY. Press the MODE button to scroll through the functions in the following sequence:
•LO → HI → AUTO → STANDBY
LO:
HI:
AUTO: In the automatic mode, the desired temperature can be set using the TEMP button.
When the ambient temperature reaches (or exceeds) the set temperature, the heater will stop heating. When the ambient temperature is below the set temperature, the heater automatically will switch to HI power to bring the ambient temperature up to the set temperature.
STANDBY: The unit does not generate any heat when in STANDBY mode. All settings are saved while in STANDBY mode.
To exit the STANDBY mode, press the Mode button until the desired mode is displayed.
•TEMP BUTTON: The temperature setting range is 41°F to 95°F (5°C to 35°C).To set the temperature, press the TEMP button and the LED display will show either the default temperature setting value of 75°F (24°C) or the last set temperature.
Press the TEMP button again to set the desired temperature value. Once the desired temperature is set, the display will show the set temperature for 5 seconds, then will display the current ambient temperature.
5
