Heat Controller SMH24SC COOL, HEAT and FAN ONLY Operation, Dry Operation, Timer Operation

Owner’s Manual Remote Controller Heat Controller, Inc.

3.COOL, HEAT and FAN ONLY Operation

A.If the AUTO mode is not desirable, manually override the settings by using COOL, DRY, HEAT (heat pump models only), or FAN ONLY modes.

B.Press the TEMP button to set the desired room temperature from 70°F (21°C) to 82°F (28°C).

C.Press the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.

D.Press the ON/OFF button. The operation lamp lights and the air conditioner starts to oper- ate per your settings. Push the ON/OFF button again to stop the operation.

NOTE

•The FAN ONLY mode cannot be used to control the temperature. In FAN ONLY mode, the fan oper- ates to create a breeze-like affect without cooling or heating the room. To cool or heat the room, change the mode of operation to COOL or HEAT.

4.DRY OPERATION

A.Press the MODE button to select DRY to dehumidify.

B.Press the TEMP button to set the desired temperature from 70°F (21°C) to 82°F (28°C).

C.Press the ON/OFF button. The operation lamp lights and the air conditioner starts to oper- ate per your settings. Push the ON/OFF button again to stop the operation.

NOTE

•Due to the difference of the set temperature of the unit and the actual indoor temperature when in

DRY mode, the air conditioner will automatically operate frequently without actually being in COOL and FAN mode.

5. TIMER OPERATION

PUSH TIMER button to set the on and off times of the unit.

A. To set the starting time.

1.Please press the CANCEL button to cancel any previous settings.

2.Press the TIMER button. The remote controller will show the TIMER and the symbol “h” is shown on the display panel. The control is now ready to reset the TIMER ON to start the operation.

3.Press the TEMP button (▲ or ▼) to set the desired unit START time.

4.After setting the TIMER there will be a one-half second delay before the remote controller transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds, the set temperature will re-appear on the digital display.

5