Heath Zenith 2LBN3 Test And Adjustment, Specifications, Maximum Range, MotionMotion, Screw, Ball

Aim Sensor

Higher for Long

Coverage

TEST AND ADJUSTMENT

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on, wait 1 1/2 minutes.

❒Turn the RANGE control to the medium position (halfway between MIN and MAX), DualBrite® to OFF, and the ON-TIME control to the TEST position.

MAX		ON-TIME	DUAL BRITE™
	O
	B
	O
	S
	T
MIN	TEST 1 5 20		OFF 3 6 DUSK TO
RANGE
		MINUTES	HOUR DAWN

Bottom of Sensor

Avoid aiming the sensor at:

•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor.

240°

15 ft.	DualZone™
(4.6 m)
DualZone™	70 ft. 100 ft.
	(21 m) (30.5 m)
	Boosted
		Maximum
Maximum Range		Coverage Angle

NOTE: If fixture is mounted higher than 8 ft.(2.4 m), aiming the sensor down will reduce coverage distance.

The detector is less sensitive to motion directly towards it.

MotionMotion

❒ Loosen the clamp screw	Clamp
in the sensor ball joint and	Screw
gently rotate the sensor.
❒ Walk through the coverage	Ball
area noting where you are
	Joint
when the lights turn on (also,
the LED will flash several
times when motion is detect-
ed).Move the sensor head up,
down, or sideways to change	Aim Sensor
the coverage area. Keep the
	Down for Short
sensor at least 1" (2.5 cm)
	Coverage
away from the bulbs.

❒AdjusttheRANGEasneeded.

RANGE set too high may increase false triggering.

❒ Secure the sensor head's aim by tightening the clamp screw. Do not overtighten the screw.

❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes).

❒Set the DualBrite® switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn).

NOTE: DualZone™ adds a zone of detection under the motion sensor. DualZone™ requires no additional adjustment and operates in conjuction with the for- ward-looking sensor.

SPECIFICATIONS

Horizontal Range. .	. Up to 70 ft. (21 m); 100 ft.
	(30.5 m) with Range Boost.
	[varies with surrounding
	temperature]
Vertical Range. . .	. Up to 15 ft. (4.6 m)
Sensing Angle. . .	. Up to 240° horizontal. Up to 80°
	Vertical
Electrical Load. . .	. Up to 500 Watts Maximum In-
	candescent
Power Requirements. 120 VAC, 60 Hz
Operating Modes. . . TEST, AUTO and MANUAL
	MODE
Time Delay . . . .	. 1, 5, 20 minutes
DualBrite® Timer. .	. Off, 3, 6 hours, Dusk-to-Dawn

DualZone™	Sensor	DualZone™
Least Sensitive		Most Sensitive

598-1115-04