Heath Zenith 5718 Installation, Mode Switching Summary, DualBrite Timer, Lamp Modes, Wall Mount

MANUAL MODE INSTALLATION

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position.

1 Second OFF

then...

For easy installation, select an existing light with a wall switch for replacement.

For best performance, mount the fixture about 8 ft. (2.4 m) above the ground.NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance.

			... back on.
	Mode Switching Summary
	TEST	Move ON-TIME Switch to
			1, 5, or 20 minutes
	AUTO		Flip light switch off
			for one second then
			back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

DualBrite® Timer

Light comes on half bright for selected time after dusk (Off, 3 hr., 6 hr., until dawn). Selecting OFF disables this feature. The motion sensing features will continue to work as described in this manual. If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 20 minutes) then returns to dim mode.

Lamp Modes

There are three lamp modes (light turn-on effects) avail- able when motion is detected:

•NORMAL - Light instantly comes on.

•SOFT - Light starts dim and gradually increases to full brightness. Light gradually dims to half-bright, pauses, and then continues dimming to off when motion is no longer detected and after selected ON- TIME.

•FLASH - Light flashes on then off twice before turn- ing on full brightness.

Wall Mount Eave Mount

For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.

For eave mount only:

❒Swing the sensor head towards the clamp screw joint.

Clamp Screw Controls

❒Then rotate the sensor head clockwise 180° so the controls face down.

Controls

Controls

If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.

598-1308-02