Lighting Controls
Meets the ENERGYSTAR® guidelines when DualBrite® function is off.
This manual applies to the following products:
•Wireless Transmitters (Indoor / Outdoor)
–180° Motion Sensor
–240° Motion Sensor
•Receivers
–Wall Switch Receiver
–Floodlight
PAGE REFERENCE GUIDE
Page 3 | Page 6 | Page 8 |
|
|
|
This manual includes operating instructions for a variety of remote controlled products. All products work on the same principle and use the same code setting information. Please read all instructional information and note any specific information pertaining to your particular product.
WARNINGS:
•FOR USE ONLY with 120 volt incandescent or halogen bulbs.
•DO NOT USE with fluorescent bulbs, appliances, power supplies, low voltage lighting, or any other electrical devices.
Features
•Products are UL/cUL and/or FCC/IC tested and approved.
•Operational range of up to 100 feet.
Heath®/Zenith wireless lighting controls are designed to work together. Simply determine which transmitter(s) you would like to have control which receiver(s) and set the code setting to match.
ENGLISH
Code Settings
Note: Most single system installations will not require any change to the code setting. Transmitter(s) and receiver(s) must have the same code and group setting to work together. Switches 1 through 3 set the code. Switch 4 sets the Group (A or B). See page 2 for switch locations.
( – Indicates Position of Switch)
Example 1 - Code Settings, System 1
(Factory Setting)
Transmitter(s)/ | Transmitter(s)/ |
Receiver(s) Code | Receiver(s) Code |
Group “A” | Group “B” |
Example 2 - Code Settings, System 2
Note: When operating more than one system independently of each other, set each system to a different code. There are 8 codes avail- able by changing the settings of switches 1 through 3.
Transmitter(s)/
Receiver(s) Code
Group “A”
© 2007 HeathCo LLC |