Heath Zenith 598-1306-02 manual Lamp Modes, Wiring Floodlight

Floodlight

Features and Ratings:

• Up to 150 Watt maximum incandescent load or 240 Watt maximum halogen load (up to 75 Watt maximum incandescent,

or 120 Watt maximum halogen, per lampholder).

•Minimal wiring required.

•Install fixture in accordance with local codes.

Lamp Modes

There are three lamp modes (light turn-on effects) available when motion is detected:

•NORMAL or - Light instantly comes on.

•SOFT - Light starts dim and gradually increases to full brightness. Light gradually dims to half-bright, pauses, and then continues dimming to off when motion is no longer detected and after selected ON-TIME.

•FLASH - Light flashes on then off twice before turning on full brightness.

WARNING: Turn power off at the fuse or circuit breaker.

1.Remove the existing light fixture.

2.Install the mounting strap as shown using two screws that fit your junction box.

Note: The plastic hanger can be used to hold the fixture while wiring. Thread the small end of the plastic hanger through the hole in the center of the cover plate. Insert the small end into one of the slots on the mounting strap.

3.Set the LAMP MODE switch to the desired light turn-on effect (Normal, Soft, Flash).

4.Route the wires from the light receiver through the large gasket holes.

5.Twist the junction box wires and fixture wires together as shown.

Secure with UL approved wire connectors.

6.Align the cover plate and cover plate gasket. Secure with mounting bolt.

7.Push the rubber plug firmly into place.

8.Not intended for waterproof junction boxes. Fixture should be surface mount only. Caulk the wall plate mounting surface with silicone weather sealant.

9.Adjust the lamp holders by loosening the lock nuts. Note: Do not rotate the lamp holders more than 180° from the factory setting.

Caution: To avoid water damage and electrical shock, keep lamp holders 30° below horizontal.

10.Screw incandescent bulb up to rated wattage into module. When screwing in the lamps, do not overtighten.

Caution: Do not exceed the maximum load limits listed above.

11.Check operation. Activate transmitter being used with receiver (see transmitter instructions).Asignal will be sent to the receiver to turn the receiver ON or OFF.

WARNING: Risk of fire. Do not aim the lamps at a combustible surface within 3 ft. (1 m).

Mounting	White to	Black to	Rubber
Strap
	White	Black
			Plug

Gasket Mounting

Bolt

Junction box ground wire to green

ground screw on fixture.

Wiring Floodlight

598-1306-02