Heath Zenith 6105 manual Motion Sensor Wall Switch, Installation, Select a Location

Motion Sensor

Wall Switch

OFF AUTO ON 6105

Included are:

•The sensor switch

•Cover plate

•3 wire connectors

•2 large screws

•2 small screws.

The SL-6105 Motion Sensor Wall Switch detects motion to turn on lights for an adjustable amount of time. A built-in photo cell can be set to keep lights off when the lights aren’t needed. The unit has excel- lent sensitivity and a wide 150° detection range. It can be used with incandescent lighting as well as rapid start fluorescent lighting.

Installation is as easy as replacing a wall switch. However, some codes require installation by a qualified electrician.

Features include:

•150° motion detection angle

•Adjustable on-time from 5 sec. to 20 min.

•Adjustable photocell

•Works with incandescent and rapid start fluorescent lighting

•Works with motors up to 1/8 hp

•Slide switch selectable OFF, ON, and AUTO modes

INSTALLATION

SELECT A LOCATION

The sensor is more sensitive to motion across the front of the sensor than to motion towards the sensor.

The detector senses heat in motion and pos- sibly heat sources that change temperature quickly. Therefore, to avoid false triggering, avoid placing the sensor where it will be aimed at air conditioners, heaters, and other sources of heat or cold.

30 ft.
(9.1 m)
15 ft. (4.6 m)	0

Figure 1 - Typical Plan View of Coverage

© 2007 HeathCo LLC 595-4881-11