Testing
1.Remove the decorative cover plate (secured by two small screws).
2.Pinch control panel cover at the indicated points as shown in Figure 5. Pull to remove cover.
Decorative
Cover
Plate
Pinch Here | Pinch Here |
Figure 5 - Removing Control Panel Cover
3.For test purposes, use a small, phillips screw- driver to turn the TIME control to the TEST (5 second) position (see Figure 6). Turn the power back on at the circuit breaker.
4.Verify the switch has power. The bottom LED will be lit.
5.Allow the sensor to stabilize (about 1 minute). The sensor is ready to detect motion.
6.Push the ON/OFF button. The lights and mo- tion sensor will turn on. The lights will remain on as long as the sensor detects motion or the ON/OFF button is pushed again. The lights will turn off 5 seconds after motion stops.
5
1 10
Test 25 15
T I M E
Figure 6 - Control Panel
Troubleshooting Wiring Connections
WARNING: Turn power off at the circuit breaker before rewiring.
1.
2.
If light does not
turn on:
If light turns on in only one position of remote switch:
Exchange* Control’s Red ⇔ Black wires.
Exchange* Control’s Red ⇔ Brown wires.
Test again. Go
to 2 or 3.
Test again. Go
to 1 or 3.
3.
If light turns
on with remote switch in either position:
Wait for the unit to warm up (up to 1 minute). If the remote switch can turn the lights on, it’s OK. Otherwise: