Chime Volume Control
(Selected Chimes)
VOLUME
CAUTION:
DISCONNECT
POWER BEFORE
OPENING
Jumper Access Door (See
Tune or Code Section)
Figure 2
Figure 3
4.Adjust volume control (Available on se- lected chimes). Unplug chime and adjust volume control to desired volume (see Figure
2). Plug chime back into wall outlet.
5.Mount push button. Use either screws or double sided tape to mount push button.
•Screw Mounting: To mount with screws, remove back of case by pushing in tab on bottom with a small screwdriver (see Figure 1). Note: Remove material in screw holes (if needed) before mounting with screws. Attach back of case to door jamb or wall (see
Figure 3). Snap front of push button on.
•Tape Mounting: When attaching push but- ton using double sided tape, make sure the surface of the door jamb or wall is clean.
